EFC International
EFC International
1940 Craigshire St. Louis,
MO 63146-4008
Phone: 1 314.434.28881
Contact: www.efc-intl.com/contact
Website: www.efc-intl.com
Print Back
These Straight NPT Threaded Economy Nylon Liquid-Tight Fittings offer cost savings and are UL approved for use with Liquid-Tight Flexible Tubing. They are available in 4 sizes; 1/4", 3/8", 1/2", and 3/4", and provide a low-cost, one-piece solution with smooth internal surfaces for easier wire routing, protection and installation. Their all Nylon 6/6 construction is resistant to salt water, weak acids, gasoline, alcohol, oil, grease and common solvents (note: this feature is not assessed by the UL certification and testing) Optional Black and Gray Collars are also available, to neaten rough cut tubing ends, and are listed. Locknuts are listed in the "Liquid-Tight Locknuts" section of our Electrical catalog.
Unit of Measure

Specifications

Temperature Index1 N/A 125 ºC

Flammability Rating

 N/A 94V-2

Across Flats

 N/A 0.750 in19.00 mm

Material

 N/A Nylon 6/6

Color

 N/A Black

Mounting Hole Size

 N/A 0.540 in13.70 mm

Thread Length

 N/A 0.465 in11.80 mm

Fits Conduit Size

 N/A 1/4 in

Nut Thickness

 N/A 0.200 in5.10 mm

Maximum Overall Length

 N/A 1.559 in39.60 mm

Ingress Protection (IP) Rating

 N/A NTP style is liquid tight

Industry Standards/Certifications

 N/A Under the Component Program of Underwriters'™ Laboratories File #E121095.

Features and Benefits

Features and Benefits

 N/A
  • Easy, permanent assembly: the installer twists the tubing over the connector ferrule, until the tubing clicks into place. It's that easy!
  • No tools needed for installation.
  • Unique locking fingers accommodate various chassis thicknesses.
  • Suitable for a wide array of electrical applications:
    • Commercial and Industrial HVAC Systems
    • Motorized Equipment
    • Enclosed Power Sources
    • Garage Door Openers
  • Major Appliances
  • If using a tapped hole , Polytetrafluoroethylene (PTFE) tape is needed on the threads of the connector, for all other applications an O-ring and Locknut are needed to attain Liquid-Tight.
  • 1 Maximum Temperature on the part shall not exceed 105ºC.