Non-Threaded Tandem-Type Shaft Retainers
Shaft & Bolt Retainers
Non-Threaded, Tandem-Type Shaft Retainers consist of strips or coils of standard rectangular Push-On Speed Nut fasteners partially sheared between each one for quick separation. With a fastener always at the fingertips, assembly time is drastically reduced. No fumbling or selecting loose, single fasteners. No waste either - each Push-On Shaft Retainer is separated after it is attached to the stud.
Unit of Measure
Items |
01335041-00Q 0.340 Inch (in) Width Non-Threaded Tandem-Type Shaft Retainer |
01C71496012000 0.340 Inch (in) Width Non-Threaded Tandem-Type Shaft Retainer |
01C18437017000 0.340 Inch (in) Width Non-Threaded Tandem-Type Shaft Retainer |
01C18437012000 0.340 Inch (in) Width Non-Threaded Tandem-Type Shaft Retainer |
01C9174014000 0.230 Inch (in) Width Non-Threaded Tandem-Type Shaft Retainer |
|||||
Description | N/A Non-Threaded, Tandem-Type Shaft Retainers consist of strips or coils of standard rectangular Push-On Speed Nut fasteners partially sheared between each one for quick separation. With a fastener always at the fingertips, assembly time is drastically reduced. No fumbling or selecting loose, single fasteners. No waste either - each Push-On Shaft Retainer is separated after it is attached to the stud. | |||||||||
Material Thickness (Decimal) | N/A 0.017 in | N/A 0.012 in | N/A 0.017 in | N/A 0.012 in | N/A 0.014 in | |||||
Width | N/A 0.34 in | N/A 0.34 in | N/A 0.34 in | N/A 0.34 in | N/A 0.230 in | |||||
Length | N/A 0.440 in | N/A 0.440 in | N/A 0.440 in | N/A 0.440 in | N/A 0.420 in | |||||
Design Variation | N/A Standard | |||||||||
Number of Retainers | N/A 15 | N/A 15 | N/A 15 | N/A 15 | N/A 50 | |||||
Per Strip coil | N/A Special | N/A Special | N/A Special | N/A Special | N/A Coil | |||||
Stud Diameter | N/A 0.082 in0.092 in | N/A 0.085 in0.095 in | N/A 0.088 in0.098 in | N/A 0.088 in0.098 in | N/A 0.089 in0.093 in | |||||
Features and Benefits | N/A Simply zip down on the stud and snap it off! Tandem-Type Shaft Retainers are ideally suited for high-speed or automated assembly where numerous fastening locations occur on a single assembly. | |||||||||
|