These Double Tube Routing Clamps hold two tubes of the same diameters, and have 2 Bolt Holes. These are available with or without vinyl plastisol (PVC) cushioning, which fully encloses the metal and can not come off during assembly or in service.

Heavy Duty Mil-Spec Cable Clamps with Eyelets are qualified to SAE AS25281 and are approved on QPL 23190. The Aluminum Eyelet in the mounting hole spreads the load and provides higher tensile strength in cable management applications where vibration is an issue. These clamps are available in Flat or Ribbed versions. Parts listed on this page are Flat.
Available for use in a wide variety of applications including military, aerospace, marine, industrial equipment, HVAC, appliance and electronics.

Heavy Duty Routing Clamps - Furnished Closed are made for applications that require a heavier or wider steel material.

Light Duty Flared Edge Routing Clamps are furnished open.

Light Duty Loop Clamps have fully radiused inside edges with size markings in inches and millimeters for easy identification. These plain edge cable clamps are designed to perform to NAS-1397P.

Medium Duty Closed Routing Clamps Furnished Open, are the most widely used of the loop-type steel clamps. The medium-duty series for bolt sizes 1/4" to 1/2" has one round and one slotted hole for easy alignment.

Clear Propionate Loop Clamps are used for 1/8" to 1-3/8" bundles, and contain a mounting hole so they are easily assembled.

When you need a more rugged clamp - the Extra Heavy Duty Clamps hold bundles from 3/4" to 1-1/32" and have an extra wide band width 7/8.

Heavy Duty Cable Clamps are made of durable nylon to secure your clamping requirements.

These Light Duty Routing Clamps are closed, furnished open. They have 2 round holes for fastener sizes #6 through #10. Contouring minimizes distortion during closing.

These Push Lock Cable Clamps are used to clamp cable or tubing securely into place. The locking feature allows preassembly on wire for ease of installation. The clamps resist corrosion, salt water, weak acids, grease, and common solvents. This feature is not assessed by UL certification or testing.

These Reusable Snap Lock Cable Clamps are used to clamp cable or tubing securely into place. The locking feature allows preassembly on wire for ease of installation. The clamps resist corrosion, salt water, weak acids, grease, and common solvents (this feature is not assessed by UL certification or testing).

This Thermoplastic P-Clamp has Aluminum Eyelets for extra support and holds 1.125" (28.60) diameter cable bundles.

These Push Mount Ratchet Clamps are interlocking clamps ("Fin Clips"), which hold from 0.990 to 1.135 diameter bundles. The parts are removable and reusable for the clamp portion. The fin clip easily snaps into a drilled hole; however, it cannot be removed. These clamps are tough, corrosion resistant and resilient.