Request Information
These 90º Sweep NPT Nylon Liquid Tight Fittings are available in seven sizes from 3/8" through 2" for use with flexible, nonmetallic Liquid Tight Conduit & Tubing listed in the "Liquid Tight Conduit/Tubing" section of the Electrical catalog. They have smooth internal surfaces for easier wire installation around the corner angles. Use of a Sealing Washer may be required for wet locations. Please refer to the "Liquid Tight Sealing Washers" section of the Electrical catalog. In addition, Locknuts can be found in the "Liquid Tight Locknuts" section of our Electrical catalog for ordering information.
Unit of Measure

Specifications

Thread Size

 N/A 1 in

Mounting Hole Diameter

 N/A 1.375 in34.90 mm

Hub Type

 N/A National Pipe Thread (NPT)

Thread Length

 N/A 0.690 in17.50 mm

Fits Conduit Size

 N/A 1 in

Locknut Material

 N/A Assembled O-Ring Metal Lockout

Maximum Overall Height

 N/A 2.833 in100.60 mm

Minimum Overall Height

 N/A 3.964 in71.90 mm

Use Sealing Washer

 N/A 20707004-A030I

Color

 N/A Gray

Material

 N/A Nylon 6/6
Temperature Index1 N/A 125 ºC

Flammability Rating

 N/A 94V-2 for nylon fittings only

Industry Standards/Certifications

 N/A Canadian Standards Association File #LL-84579 and #LR-81067.
Listed under Underwriter's Laboratories File #E-28430.

Features and Benefits

Features and Benefits

 N/A
  • Unitary design and assembled shipment allows fast fit.
  • No threading of the conduit or tubing is required to install.
  • Locknuts NOT included, refer to Locknuts section of Electrical Engineering Guide for Nylon Locknuts.
  • Suitable for use by original equipment manufacturers. Vibration and tamper resistant, but easily removed with a screwdriver.
  • Consult EFC International directly for FPAX fittings for use in IP 68 or 67 (as well as 66) applications.
  • Unitary design and assembled shipment allows fast fit.
  • Sealing Washers also available - please refer to the Electrical section of this Engineering guide.

Note

Note

 N/A Takes Sealing Washer
  • 1 Maximum Temperature on the part shall not exceed 105 ºC.
Product Catalog